Upgrading my shop built router table with a new router and router plate. Part 2 of 2
|
|
|
|
|
Upgrading my shop built router table with a new router and router plate. Part 2 of 2
2 Comments
KDawg
3/20/2013 08:10:46 am
At then end of the post, you mentioned a "Safety Switch"? What did you mean by that?
Shawn Sealer
3/27/2013 12:16:54 pm
The power switch clicks off on the router when the Collete is raised all the way up to change the bit. since I am using a paddle switch on the side of my router table to turn the router on and off. I must turn the switch on the router to the on position before the paddle switch will work as the main on off switch. Leave a Reply. |
PODCASTS
Archives
April 2021
Categories
All
|
RSS Feed
